THE QUANTUM HARMONIZER SPACE SHIELD

The Quantum Harmonizer Space shield is designed to protect your physical space from negative and unbalanced energies. The shielding will protect your home, office, store or any area that has electricity and needs protection.

The Holographic Shield contains countless frequencies designed to protect and enhance your overall state-of-being. The frequencies contained in the Holographic field use the power-field created by the wires running through the electrical wiring in any space to help you evolve rather than work against you. It has been designed to help you grow to your fullest potential as well as clear your space of unwanted energetic debris.

The Harmonizer is fully contained, requires no effort on your behalf to work, and can be taken with you if you move. The effects are ongoing. There is a break-in period, usually lasting anywhere from 24-72 hours, where some awkwardness or discomfort may occur. Folks often find themselves cleaning furiously, or even sleeping a bit more than usual, during the break in period. Once the period has ended, your new space will be much more in alignment with the true you. The effects can be subtle and not so subtle, there is no set response the process, but the Harmonizer always works and it always has some effect.

The key word associated with the Harmonizer is “clarity.” The Harmonizer brings clarity to the place you spend your time in. You’ll feel more comfortable, more relaxed, more balanced in the field created by the Harmonizer. The field will, on average, extend out 1500-2500 feet around it – your neighbors will thank you for it.

Placement:

1. Locate your Circuit Breaker Panel, or your Fuse Box.
2. Remove the adhesive film covering from the squares.
3. Place the Harmonizer directly over the center of the box, careful not to block access to the door. If you need to move the adhesive squares, feel free to do so.
4. If you box is outside, or you feel uncomfortable about having it on the outside, you may place the Harmonizer on the inside of the box by attaching it to the door. Do not attach it to the breakers themselves, place it on the inside of thebox with the tape attaching to the door and the Harmonizer facing the breakers.
5. The Box or Panel nearest the meter is best – if you have two or more. If you must move the device, or it has fallen for some reason, more double stick tape or silicone household glue will work just fine.
6. If you have bought a Harmonizer and cannot place it on the box for some reason or another, take the two strips of velcro provided. Remove the adhesive film and place one part of the velcro on the Harmonizer horizontally in the center. Then place your unit around any power cord in the house – a power strip is perfect. Then enclose the cord with the other piece of velcro, tightening it to secure the Harmonizer to the cord. The Harmonizer should sit like a sign on your power cord when done.

Place the Harmonizer directly on the panel. Small rectangle goes to the top. This meter is shielded from the elements, if yours is not, open the door, place the Harmonizer inside.




If your panel is outside, or you don’t want the Harmonizer to be seen, open the panel door and place it inside, mounting it to the door itself. Small rectangle goes to the top. Make sure the door will close and the Harmonizer does not touch any of the breakers.




If you do not have access to the panel, remove the adhesive squares. Place the velcro strips provided on the Harmonizer and place the power-cord in between the velcro strips. If you use the corded method, place the two devices that com with are far from each other as possible. Placing one in conjunction with the power-strip containing the most electronics - typically the media center, is best.