THE QUANTUM HARMONIZER INSTALLATION
THE QUANTUM HARMONIZER SPACE SHIELD
The Quantum Harmonizer Space shield is designed to protect your physical space from negative and unbalanced energies. The shielding will protect your home, office, store or any area that has electricity and needs protection.
The Holographic Shield contains countless frequencies designed to protect and enhance your overall state-of-being. The frequencies contained in the Holographic field use the power-field created by the wires running through the electrical wiring in any space to help you evolve rather than work against you. It has been designed to help you grow to your fullest potential as well as clear your space of unwanted energetic debris.
The Harmonizer is easy to place.
Placement
- Locate your Circuit Breaker Panel, or your Fuse Box.
- Remove the adhesive film covering from the squares.
- Place the Harmonizer directly over the center of the box, careful not to block access to the door. If you need to move the adhesive squares, feel free to do so.
- If you box is outside, or you feel uncomfortable about having it on the outside, you may place the Harmonizer on the inside of the box by attaching it to the door. Do not attach it to the breakers themselves, place it on the inside of thebox with the tape attaching to the door and the Harmonizer facing the breakers.
- The Box or Panel nearest the meter is best – if you have two or more.
- If you must move the device, or it has fallen for some reason, more double stick tape or silicone household glue will work just fine.
- If you have bought a Harmonizer and cannot place it on the box for some reason or another, take the two strips of velcro provided. Remove the adhesive film and place one part of the velcro on the Harmonizer horizontally in the center. Then place your unit around any power cord in the house – a power strip is perfect. Then enclose the cord with the other piece of velcro, tightening it to secure the Harmonizer to the cord. The Harmonizer should sit like a sign on your power cord when done.
**To change your Harmonizer Shield to a Power-cord version, simply remove the adhesive and attach the velcro strips.**
Power-cord Version
The Power-Cord version works on any power-cord. A power strip is perfect. Simply open the velcro, place the cord inside, and close the velcro. You can add a few cords to the device - if you have a computer setup or other multi-corded situation. You may take the device with you when you travel, simply attach it to any power cord in the room you are staying in - don’t forget to take it with you.
*******************
Some Circuit Breaker panels will be located inside, simply place your device either inside the box or outside the box and you are done. If your box is located outside, and exposed to the weather, place it inside the box. If your Circuit Breaker panel is outside, but protected from the weather by a shed or box, then simply place the device where it is most comfortable.
***This does not attach to any power source, please to not attempt to place this in contact with any electricity at all, as injury or worse may occur.